Dry Section
Processing technologies of mineral sand production based on their physical characteristics at pilot plant ,Cox's Bazar By lftekhar uddin chowdhury,BSMEC, B,A.E.C,Cox,sBazar
Dry operation process is applicable to drying ,screening ,air classification for
magnetic, non magnetic ,non conductor, Conductor for quality product. Category
equipment is used for this purpose are, lime, w.h.i.m r m s ,crossbelt,for separator
Which is mainly dealing with magnetic properties. High tension separator,
electrostatics, Esp. separator are used for conductor And non conductor properties.
Table concentrate from wet plant as primary non conductor heavies is then feed in
the rotary drum drier up to 90-100;c temperatures. the dried up minerals thus
obtained are lifted to high tension roll separator by bucket elevators H.T. S operate
at Around 35000- 4000dc voltage which to applied to separate conductor from non
conductor fraction. Those conductor fraction is again passed through induced
magnetic separator and diverted to cross belt and bucket elevator to Separate
magnetic conductor and non magnetic fraction high intensity magnetic is run at 0,5 —
1 amp and 200-250 rpm for it As result ilmentite nearly 95-97%grade may be
available non magnetic fraction which is contains rutile as a non conductor Is again
diverted through the same process in H.I magnetic separation which is run at 2.5-
amp and 40-60 rpm to get zircon As a non conductor ,non magnetic. the product is
then passed through shaking table via hydrocylone. Table consecrate Gives zircon
production . again air classification for up gradation if need . garnet and monazite
which is obtained in magnetic and non magnetic is again subjected to Kasson
vibroscreen to upgrade of garnet over size 88-85% under trace monazite Physical
characteristics of mineral sand production in the plant.
Mineral Specific Hardness Magnetic Electrical I Grain size !
gravity properties _ properties range
Zircon 4.69 " 7-7.5 Non - Non 0.25-0.o63
_ Magnetic conductor :AI Vlx
Rutile 4.20 5.55 Non Conductor do
__ magnetic
Ilmenite 4.70 5-6 Low Good do
magnetic conductor
Garnet 3.8-4 6-75 Moderate Non Do
magnetic conductor —
Monazite 4.60 5-5.5 Weakly Non 0.25+0063
magnetic conductor
_._
Kyanite 3.56 4-5.5 Moderate Non do
mag conductor
Quantity of mineral sand deposits located in the costal belt of Bangladesh is reported to be
approximately 4.4 million ton heavy mineral with average 18% of heavy minerals .and it is
suitable for mining either -by wet dredging or dry using earth moving equipment , excavate
and transport the sands .but it has no environmental affect. Australia, sri lanka, India, south
Africa, u.s.a, Malaysia. brazil, Bangladesh are major producer of this minerals . and its
consumed many countries of the world ,including Bangladesh .so it is observed that% grade
of individual mineral achieved in the pilot plant separation varies depending on the deposit
of raw sands .however. pilot plant processing for individual separation has attained
remarkable progress some of mineral production such as magnetite.ilmenite.have been
already reached in commercial grade . the grade of zircon and garnet, is nearly commercial.
Pilot plant small scale production is may be Capac able of demand in our country, if
consumer is Surety of constant ly intending .paper mill, Bangladesh oxygen, pigment
industries and many ceramic industries. Bangladesh insulator and sanitary ware factory,
paper mill, rubber industries. Bangladesh welding electrodes Rahim steel mills, and a few
chemical factory .t.v face plate. Industries, steel mills ,are major users of this mineral of our
countries, titanium, and zirconium Bearing sands and other valuable mineral recovering is
very essential of the country.so that Exploitation initiatives should be, taken for setting
2 comments:
Any one asked qustion from me
Any one asked qustion from me
Post a Comment